Molex To SATA Power Cable

A standard Molex to SATA Power cable is shown below.

std%20molex%20to%20sata.jpgFour_Pin_Molex_Connector01.png
ConnectorMolex1-1.png

On a Topfield PVR the position of the red and yellow cables on the Molex end are reversed while the SATA end is kept standard.

Topfield connector has the Red and Yellow wires reversed from the standard above so that

Pin 1 = Red +5VDC
Pin 4 = Yellow +12VDC

So the final wire connections should be as follows:
Four_Pin_Molex_Connector01_For_Topfield.jpg
Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License